No-Bolt Assembly
Metalware's No Bolt interlok shelving as simple to assemble |
||||
Click here to open the PDF installation sheets. |
||||
| 1 . How to install a shelf clip - Take the shlef clip holding the long end up, insert the long end into the post hole, at the desired height. Insert the short end of the shelf clip in the hole below. |
||||
| 2 . Installing 2 clips on one post for side by side units - Insert the shelf clip in the same holes but on the opposite side of the posts. This will allow for shelves on either side of the post. |
|
|||
| 3. Installing a shlef - Insert a clip (like in step 1) at the desired height on the 4 posts. Placing the shelf on an angle, insert it into the shelving unit and press firmly down on the corners to engage the clips. |
||||
| 4. Installing isde braces - Bolt the braces to the T-Posts in an "X" pattern in the middle of the unit.
|
||||
| 5. Installing back braces - Place the back braces in an "X" pattern at the desired angle and bolt to the shelving unit posts - mid-height of the unit.
|
||||
Click here for the shelving spec sheet.
