Metalware’s Interlok No-Bolt design is based on three guiding principles:
 |
Strength: The ultimate in strength and rigidity has been obtained by the wedge-type combination of shelf and brackets |
|
 |
Economy: Assembly cost is a vital factor. Interlok No-Bolt eliminates obsolete methods of assembly. Nuts, bolts and tools have been removed from the equation, saving up to 80% of assembly time. | |
 |
Efficiency: Shelves can easily be rearranged and all component parts installed without dismantling. Interlok No-Bolt is the only shelving completely assembled in an upright position. There is no additional floor space needed for the process of assembly. | |
Among the most rigid in the industry, Metalware shelving is produced in 18-gauge cold-rolled steel. Shelves are made of double-bends on all four sides, complete with closed corners. The uprights are made of 16 gauge hot-rolled steel and are pre-punched, roll-formed, welded and cut to length in on continuous operation.
Interlok No-Bolt steel shelves are designed for maximum strength and durability. A superior quality shelf has been obtained by combining these exclusive features:
| Double folded closed corners for maximum support |
A two-way locking principle at each corner. |
1 3/16” flange on |
For heavier loads reinforcing bars are imbedded in the front and rear of the shelf. |
All shelves are punched for Bin Dividers. |
||||
| Click on the photos to view the next one. |
||||||||
Click here for the shelving spec sheet.
